GeoCloud Fleet
English Czech Danish Dutch Finnish French German Italian Japanese Norwegian Bokmål Polish Portuguese Spanish Swedish

Updating device firmware/software remotely - New

Live software version

Fleet shows the software version installed on a registered device, in the device's property panel. The device reports this value itself, and it updates automatically whenever the device connects to the internet.

What are remote software updates? NEW

With remote software updates you can install a new Captivate software version on your Leica GS05 directly from Fleet, without a cable and without bringing the device back to the office.

When a newer version is available for a GS05, Fleet tells you, and you can install it from the device's property panel in the web app or the mobile app.

Requirements

To update a device remotely:

  • The device is a Leica GS05 registered in your company account

  • The device runs Captivate 11.0 or later

  • The device has an active CCP, synchronised on the device

  • The device battery is charged above 30%

  • The device can connect to the internet via Wi-Fi or cellular (specific variants)

Install a software update

All user roles can install a software update, in the web app and in the mobile app.

  1. Open the Device list. Devices with an available update are marked.

  2. Click the device to open its property panel.

  3. Click Install update and confirm.

Then:

  • The installation runs in the background. The device can still be used.

  • You can follow the status of the installation in Fleet.

  • If the device is offline or switched off, the installation is scheduled and starts automatically when the device goes online.

  • When the installation is complete, reboot the device to start using the new version.

Note: when the device is connected via cellular, the download uses mobile data.

🧩 Troubleshooting

Problem

Likely cause

Resolution

Fleet shows an outdated software version

The device has not connected to the internet recently

Connect the device to the internet: TS20 via its GMI01 module (cellular), GS05 via Wi-Fi or cellular (specific variants), CS50 via Wi-Fi or cellular. The version then updates automatically

No update is shown for the device

The device already runs the latest version

No action needed

Fleet asks for a manual software update

The device runs a version older than Captivate 11.0

Update the device once via cable. Future updates can then be installed from Fleet

The software version is unknown

The device has never connected to the internet

Connect the device to the internet

The installation stays scheduled

The device is offline or switched off

Switch the device on and connect it to the internet.

If the issue persists, try to connect to a high-speed network


The device's Wi-Fi settings were overwritten by a field controller. When a Leica field controller connects to the GS05, it can replace the GS05's Wi-Fi settings

Set up the Wi-Fi connection on the GS05 again

The installation failed: battery

The battery was below 30%

Charge the device and try again

The installation failed: CCP

The CCP is not active, or not synchronised on the device

Renew the CCP if needed, synchronise it on the device, and try again

The installation failed

Other reasons

Try again. If it keeps failing, please reach out to support

Fleet still shows the old version

The device has not been rebooted yet

Reboot the device

Frequently asked questions

Can I still update the device via cable?
Yes. Updating via cable remains possible. Fleet shows the new version the next time the device connects to the internet.

Can I cancel an installation?
Not at the moment.